Triple Clamp Set， CNC， Race， HRC Style， SP1

Following Items ：
Bearing Headstock Upper ( x 1 )
Top Triple Clamp Nut (M24x1) ( x 1 )
Bearing Headstock ( x 1 )
Seal， Headstock ( x 1 )
Caphead Stainless， M8x20 ( x 2 )
Caphead Bolt， Stainless， M8x45 ( x 6 )
Top Triple Clamp， CNC， Black， Race， HRC Style， SP1 ( x 1 )
Lower Triple Clamp， CNC Silver， Race， HRC Style， SP1 (No fittings) ( x 1 )
Spacer， Top Triple Clamp， Race， HRC Style SP1 ( x 1 )
Steering Stopper， Silver， for SP1/SP2 Triple Clamps ( x 2 )
※画像はイメージです。
※取扱説明書が付属する場合は外国語となります。
※輸入商材の為、納期が遅れる場合がございます。あらかじめご了承ください。
※メーカー都合により商品の仕様変更がある場合がございます。ご了承ください。
Triple Clamp Set， CNC， Race， HRC Style， SP1
Designed and machined in house as a race replacement for the OEM triple clamps.
Crafted from aircraft spec 6061-T6 alloy for minimum weight and maximum strength.
The fork pitch and offset are the same as the OEM clamp.
Please note that this triple clamp set is for race use only， with reduced steering lock compared to the OEM triples， and was designed with the full HRC setup in mind.
The lower clamp includes mounting position for a steering damper by way of an integrated M8 boss. No damper mounting hardware is provided.
Also， the top triple clamp has no provisions for mounting the ignition switch， so an alternative mounting position for the ignition switch must be found.
For correct fitting of the top triple clamp， the top preload lock nut and locking washer must be removed， and replaced with the TYLY-0370C spacer. This is the same fitting style as the true HRC setup.
If you are looking for SP2 triples， please see the following products：
TYLY-2371 Triple Clamp Set， CNC， Race， HRC Style， SP2
TYLY-0371 Top Triple Clamp Set， CNC Black， Race， HRC Style SP2
TYLY-0373 Lower Triple Clamp Set， CNC Silver， Race， HRC Style， SP2
Tightening recommendations：
Lower clamp pinch bolts： 23Nm.
Top clamp pinch bolts： 23Nm.
Fork Pitch： 214mm.
Fork Offset： 30mm.

ユーザのインプレッションを見る

適合車種： VTR1000SP ( 適合車種を見る )